ERROR CODE |
ERROR |
CORRECTION OF ERROR |
00 |
No error recognized |
-- |
01 |
Inside temp sensor G56 (instrument channel), open circuit |
Check affected component and related wiring according to wiring diagram. |
02 |
Inside temp sensor G56 (inst panel), short circuit. |
Check affected component and related wiring according to wiring diagram. |
03 |
Outside temp sensor G57 (plenum) open circuit |
Check affected component and related wiring according to wiring diagram. |
04 |
Outside temp sensor G57 (plenum) short circuit |
Check affected component and related wiring according to wiring diagram. |
05 |
Outside temp sensor G57 (cowl) open circuit |
Check affected component and related wiring according to wiring diagram. |
06 |
Outside temp sensor G57 (cowl) short circuit |
Check affected component and related wiring according to wiring diagram. |
07 |
Feedback potentiometer on adj motor for temp reg flap, V68 (interruption / open) | Check temp regulating flap servo motor V68 (w/ feedback potentiometer) SEC D8-190 |
08 |
Feedback potentiometer on adj motor for temp reg flap, V68 (short circuit) | Check temp regulating flap servo motor V68 (w/ feedback potentiometer) SEC D8-190 |
09 |
Coolant temp sensor G62, open circuit | Check coolant temp sensor G62 and its wiring according to diagram. |
10 |
Coolant temp sensor G62, short circuit | Check coolant temp sensor G62 and its wiring according to diagram. |
11 |
Inside temp sensor G68 (roof), open circuit | Check inside temp sensor (roof) and wiring... |
12 |
Inside temp sensor G68 (roof), short circuit | Check inside temp sensor (roof) and wiring... |
13 |
Electrical system voltage is or was once less than 9.5V but greater than 5V during the current driving period. Note: Values less than 5V are recognized as open low pressure switch. | Check electrical system voltage display. Section D8-260 |
14 |
Compressor off; high pressure switch F118 (red housing) cycled 8 times. | Check high pressure switch F118 (sec D8-230) |
15 |
Adjustment motor for temp reg flap V68 (with feedback potentiometer) is set improperly. | Check temp regulating flap servo motor V68 (w/ feedback potentiometer) Sec D8-190 |
16 |
High pressure switch F118 has open circuit or cycled at least one time during current driving period. | Check high pressure switch F118 (red housing) and it's wiring according to wiring diagram. |